MEK

Flat washer for switches with 12mm bushing

Outer diameter: 19mm
Inner diameter: 12mm
Thickness: 2mm
Material: Acrylic

Circuit board to the making a hot cake clone, drilled and sealed with soldering varnish, fitting for Hammond 1590 B. See category Kits for effects [...]

Kit to build an 8-fold multi effect with DB-FV1 8XX
Motherboard with all the necessary components, without knobs, incl. a DB-FV1 8XX module of [...]

Preprogrammed Chip with ENVGNE7B (Voltage Controlled ADSR Envelope Generator)by Electricdruid, PIC 2Kx14 Flash, 12 I/O, 20MHz, case DIP14- Envelope [...]

Only available in german!!!

Supplementary kit Bank Expander for 8-Looper / switch ISL888P
Using the kit's can be managed on the device [...]

Faceplate for the kit plexiclone. Fit for the enclosure Eddystone 29830 PLSA.
Dimension: 116x90x1.6mm

  Digitales Effektmodul

Kit to build 4 extra stages for the Ross Phaser (switchable).
Dimension PCB: 52x28.6mm
Include:

PCB and all electronic and [...]

Only available in german!!!

PCB set for 8-fach Looper/switch System with MIDI control.
Complete pcb's with preprogramed [...]

Level: Advance

Kit to build modern SLO-100 emulation . You need only 6 knobs (6,4mm)(with a max. diameter of 16mm- 6.4mm shaft) if use a [...]

Attention! Not a project for beginners

Kit to build the electric druid 4 knob flanger --> Tom Wiltshire -->

Preprogrammed Chip with LOOPENV1B (Voltage Controlled ADSR Envelope Generator)by Electricdruid, PIC 2Kx14 Flash, 12 I/O, 20MHz, case DIP14- Envelope [...]