MEK

Preprogrammed Chip with LOOPENV1B (Voltage Controlled ADSR Envelope Generator)by Electricdruid, PIC 2Kx14 Flash, 12 I/O, 20MHz, case DIP14- Envelope [...]

Attention! Not a project for beginners

Kit to build the electric druid Multi Flanger by Tom Wiltshire -->

Connection cable for IDC connectors (eg Modular System A-100) 16 pole gray -> 16-pin male to 16-pin male with strain relief.

Module for the construction of an amplifier up to 100W.
Prefabricated and tested DMOS amplifier module.
Single-sided PCB with silkscreen, [...]

DIY Kit Bus board for A-100 / MOTM systems for installation in rack enclosure 84TE
- 14 slots for A-100 system
- 12 slots for the MOTM [...]

Double side bus board for A-100 / MOTM systems for installation in rack housings 84TE
- 14 slots for A-100 system
- 12 slots for the MOTM [...]

Kit to build an 8-fold multi effect with DB-FV1 8XX
Motherboard with all the necessary components, without knobs, incl. a DB-FV1 8XX module of [...]

Only available in german!!!

PCB for 8-fach Looper/switch System with MIDI control.
pcb with preprogramed controller.
+ [...]

Adapter box with switch (on-off) for 9V battery (6F22) with connection to DC plug 5.5mm / 2.1mm with standard polarity + outside - minus inside. [...]

Kit to build a ProCo Rat clone.
You need only 3 knobs knob's for shaft with a diameter of 6,35mm (max. diameter 20mm if use a 1590B enclosure) [...]

Double sided PCB to build the www.freestompboxes.org Weasel V84. Credits goes to Bajaman Newzealand. Thanks.

Dimension: 87x57.4mm

Webproject of www.freestompboxes.org for the construction of a Diezel VH4 simulation. Designed by Bajaman New Zealand. Thank you.
Only 7 [...]