MEK

Kit to build a SuperOverdrive SOD-44. You need only a enclosure and 3 knobs for pots with 6,35mm shaft with a max. diameter of 20mm
Decals [...]

Printboard to build a bor clone, single side, solder mask, silkscreen. Ground fault, solder a bridge. Identical to the standard Kit
Dimension: [...]

PCB for building a Zentaurus, drilled, soldering mask, silk screen. Dimension 85x45mm. Fit for a 1590BB enclosure

PCB for building a Plexiclone, Double sided, drilled, soldering mask, silk screen. Dimension 110x25mm. (1590 BB).

PCB for building a Wah. single sided, drilled, soldering mask, silk screen. Dimension 70x55mm.

PCB for building a bass overdrive "Bass Amuser" of the thread at the musikerboard.
Single side pcb with silkscreen, dimension : [...]

Sold out!!
Level: Advanced

Attention: this kit is not a beginners project! The voltages can +/- 60V DC and more, and are absolutely [...]

PCB for building a digital delay with HT8955A and DRAM. Delay time approx 0.8ms. Double side pcb, silkscreen, soldermask.
Dimension: [...]

Kit to build digital delay with the HT8955A and 256K Dram. You need only 3 knobs for shaft 6.35mm (1/4") and a enclosure e.g. 1590BB.
Using the [...]

PCB for building a Ze(h)ndrive. Single side pcb, silkscreen, soldermask.
Dimension: 46x36mm.

Preprogrammed CHIP with TAP function for the PT80 delay or other circuits with PT2399 and 50K time pot., case DIP8

Level: Advance

Material composition for the bass overdrive "BassAmuser" from the musicians Board. All components incl. Hammond 1590BB raw [...]