New Products

Kit for building a Forest Green Compressor (FGC)

The development and circuit are from Chris [Tech One].
For technical questions, [...]

Kit to build a germanium fuzz face with negative ground. You need only 2 Knobs (1/4") and a enlosure minimum 1590B.


Inhalt:

1x [...]

Kit to build a silicon fuzz face. you need only 3 knobs (1/4" max. diameter 20mm) and a enclosure.


Contents:

1x 3PDT [...]

Kit to build a germanium Fuzz Factory with negative ground. You need only 5 knobs (6mm for 18-teeth shaft) with a max. diameter of 19mm and a [...]

Module to select the 8 programs of FV-1 chip (external or internal programs). Compact 8-pole rotary switch, PCB, pregrommaed PIC
1x [...]

Kit to build a Hotcake clone. you need only 3 knobs (max. diameter up to 20mm/ shaft 6,35mm - 0.25")and a case of min. 1590B, 1550B, [...]

Kit to build a active splitter box with a isolated output to drive 2 amps without hum. You need only a enclosure of min. 1590B, 27134 [...]

Level: Advance

Kit to build a JCM800 emulation model 2203 e.g. 2204. You need only 6 Knobs (max. diameter of 16mm - 1/4" if use a 1x6 [...]

Kit for building a Jen Rey Overdrive

The development and circuit are from Chris [Tech One].
For technical questions, Chris can be [...]

Kit for building a JHMD-1. The kit is based on the overdrive channel of the Marshall Jackjammer. Well suited for crunch to fat board (almost high [...]

Kit to build a silicon linear booster. You need only a knob (1/4") and a enclosure e.g. 1590A or greater.
Can't powered by a battery if used a [...]

Kit to build a bass fuzz. You need only 4 Knobs for shaft split shaft T18 or 6mm shaft (max. diameter 20mm) and a enclosure min. [...]